The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> dcmatch sweep analysis in Cadence often fails https://designers-guide.org/forum/YaBB.pl?num=1170834081 Message started by gsheng on Feb 6th, 2007, 11:41pm |
Title: dcmatch sweep analysis in Cadence often fails Post by gsheng on Feb 6th, 2007, 11:41pm When I ran dcmatch sweep analysis, spectre always failed to converge. But when I ran simple dcmatch(just one value), it seems to be OK. Any comment? |
Title: Re: dcmatch sweep analysis in Cadence often fails Post by Andrew Beckett on Feb 7th, 2007, 3:42am Does the same thing happen if you do a dc sweep (sweeping the same thing you're sweeping in the dcmatch)? Regards, Andrew. |
Title: Re: dcmatch sweep analysis in Cadence often fails Post by gsheng on Feb 13th, 2007, 5:03am dc sweep is OK. |
Title: Re: dcmatch sweep analysis in Cadence often fails Post by Andrew Beckett on Feb 22nd, 2007, 11:54am I find this surprising. You should report this to Cadence customer support. Regards, Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |