The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> Error Message in AMS https://designers-guide.org/forum/YaBB.pl?num=1172264017 Message started by danda821 on Feb 23rd, 2007, 12:53pm |
Title: Error Message in AMS Post by danda821 on Feb 23rd, 2007, 12:53pm I am using Cadence AMS to simulate a dff, and got the following error message when run the simuation: ncsim(1) *E, RNAERR (No HDL source, 0|0): Simulation is complete, analog initialization error. ------------- The analog simulator detected an unrecoverable error condition during run-time initialization. Simulation cannot proceed. But if I use verilog model for dff, it runs fine. It only happans when I switch to spectre model. Thanks. |
Title: Re: Error Message in AMS Post by danda821 on Feb 23rd, 2007, 2:03pm I found some warning message during netlist: Warning: Parameter "pam1" found in "instParameters" list of AMS simulation information (mapped to "pam1" in CDF) does not exist in base cell CDF ("cmrf8sf" "nfet"). Warning: Parameter "pam2" found in "instParameters" list of AMS simulation information (mapped to "pam2" in CDF) does not exist in base cell CDF ("cmrf8sf" "nfet"). where can I find the "instParameters" list of AMS simulation information? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |