The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> Shielding on differential lines https://designers-guide.org/forum/YaBB.pl?num=1173354792 Message started by fonseca.ha on Mar 8th, 2007, 3:53am |
Title: Shielding on differential lines Post by fonseca.ha on Mar 8th, 2007, 3:53am I have an audio sensitive differential signal to route accross the chip, between a driver and a receiver. This line is to be shielded but I have one doubt. Is it better to connect the shield to the ground on the driver side or on the receiver side? Thank you |
Title: Re: Shielding on differential lines Post by chase.ng on Mar 12th, 2007, 8:09pm The shielding ground should be connected at the receiver side. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |