The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Mixed-Signal Design >> 0.13um bandgap https://designers-guide.org/forum/YaBB.pl?num=1173928386 Message started by jim on Mar 14th, 2007, 8:13pm |
Title: 0.13um bandgap Post by jim on Mar 14th, 2007, 8:13pm Dear all, We want to design the bandgap reference with 0.13um process 1.2v device, Is it ok? Thanks in advance, Jim |
Title: Re: 0.13um bandgap Post by SATurn on Mar 18th, 2007, 7:48am It highly depends on the specs you wish achieve. In general, it is possible to design very low-voltage BGRs, even below 1.2V (you can have a look on IEEExplorer). In this case of course the reference voltage would be smaller than the usual value (i.e., 1.12V). SATurn |
Title: Re: 0.13um bandgap Post by jim on Mar 19th, 2007, 12:43am Dear SATurn, Thanks a lot for your reply,It's a pity that I haven't a IEEE account, so I couldn't download paper from it . Could you please forward some papers to me? email address: fujj_2003@163.com Thank you very much and best regards! Jim |
Title: Re: 0.13um bandgap Post by chase.ng on Mar 20th, 2007, 12:49am The theoritical minimum headroom for current mode bandgap can goes down to vbe+vdssat which can be lower than 1 V. However, as the voltage goes lower, I found it harder to achieve good accuracy. Regards, Chase |
Title: Re: 0.13um bandgap Post by SATurn on Mar 21st, 2007, 10:35am Let me try. SATurn |
Title: Re: 0.13um bandgap Post by fangjh on Apr 8th, 2007, 6:03pm Hi:jim I have design 0.13um bandgap, and the output voltage is 0.525v, the chip's performance have some problem , you should be care the start up circuit 's margin, otherwise the bandgap should not be start normal, other parameter is ok, 1V-1.4v: variable 4mv and temp 0-85c : about 3mv. |
Title: Re: 0.13um bandgap Post by jim on Apr 27th, 2007, 12:36am Hi fangjh, Thanks a lot for your reply. Jim |
Title: Re: 0.13um bandgap Post by loose-electron on May 23rd, 2007, 5:44pm Have you considered doing a 1.2V output BG (flattest thermal response) and using the I/O transistors? Also, if you dont have the 1.6V (give or take) to run that, you can use charge pumping to create it internally. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |