The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> how to measure the THD of sample and hold circuit https://designers-guide.org/forum/YaBB.pl?num=1173942845 Message started by manisms on Mar 15th, 2007, 12:14am |
Title: how to measure the THD of sample and hold circuit Post by manisms on Mar 15th, 2007, 12:14am how i calculate the THD of sample and hold circuits in cadence tool actually the normal procedure as the select the net and take special function of THD and then plot . but this is ok with the continuous wave and any amp. but here the input signal is getting sampled at every clock cycle. so i need to calculate the THD ...in this regards. and please tell me how to measure the gain error and nonlinearity and pedestal error of s/h circuit in cadence .. and docs for test benchs available plese please send to me.. i will be really obliged .. regards |
Title: Re: how to measure the THD of sample and hold circ Post by vivkr on Mar 15th, 2007, 6:22am Hi, I would recommend using the strobe feature of transient analysis to begin with. This guarantees that the simulator places a timestep at the point where you want to observe the sampled output. Without this, you are likely to get very bad results. After this, you can use the inbuilt "dft" function of the calculator. However, this feature which used to work well earlier seems to give me some trouble nowadays. So, I print out the output values into a text file at the strobed points, and perform an FFT with any convenient tool - MATLAB, Excel etc. Normally though, the calculator should do a good job if you have properly strobed the output at the right point. Regards Vivek |
Title: Re: how to measure the THD of sample and hold circ Post by Andrew Beckett on Mar 15th, 2007, 6:24am PSS or QPSS (depending on the frequency relationship) is how I'd do this. See http://www.designers-guide.org/Analysis/sc-filters.pdf Regards, Andrew. |
Title: Re: how to measure the THD of sample and hold circ Post by manisms on Mar 17th, 2007, 8:18am hi VVkr thanz for reply .. as i am not very use to this cadence tool. my question is that when i havea strobed the output of my s/h in transient analysis and run my simulation. then after running the simulation if i plot the output it will show me the result of output where i strobed the signa. then after that what i will do means how i proceed to calculate the thd . i want to know the procedure of which net i click and choose the dft funtion in calculator. please tell me how i proceed as i am very new for this tool. hope u will help . regards manish |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |