The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> Psrr specification https://designers-guide.org/forum/YaBB.pl?num=1176373939 Message started by ioannis on Apr 12th, 2007, 3:32am |
Title: Psrr specification Post by ioannis on Apr 12th, 2007, 3:32am Hello, my main target is to verify the output characteristics of an amplifier. For test reasons I picked the OpAMp from Analog Devices OP-420G. In addition I found this howto article: http://www.automotivedesignline.com/howto/securitysafety/194500113?term=macro&x=&y= Now I’m interesting to simulate the PSRR characteristic as it is show in the article above! I do the simulation with hspice. How do I have to proceed? ioannis |
Title: Re: Psrr specification Post by ywguo on Apr 12th, 2007, 4:06am Hi, If you have a SPICE model of analog devices OP-420G, of course you can simulate PSRR using the configuration shown in the article. Yawei |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |