The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> how to change the axis variables in Cosmos Scope
https://designers-guide.org/forum/YaBB.pl?num=1177317403

Message started by Julian18 on Apr 23^rd, 2007, 1:36am

Title: how to change the axis variables in Cosmos Scope
Post by Julian18 on Apr 23^rd, 2007, 1:36am

Hi, there.
I wonder if it is possible to change the default axis variables (time, frequency,etc.) to another variable, such as voltage, current, or even user defined parameters, If possible, how could i do that?

TIA!!

Julian

Title: Re: how to change the axis variables in Cosmos Sco
Post by Geoffrey_Coram on Apr 23^rd, 2007, 4:13am

Once upon a time I did an ac analysis with a dc sweep; the default axis was frequency, but I was able to switch to plotting the variables against the dc sweep variable (voltage in my case).