The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Mixed-Signal Design >> common mode noise. https://designers-guide.org/forum/YaBB.pl?num=1181236574 Message started by smarty on Jun 7th, 2007, 10:16am |
Title: common mode noise. Post by smarty on Jun 7th, 2007, 10:16am Hi, I am working on high speed receiver. I am simulating the differential receiver for performance. I would like to test the receiver by injecting AC common mode noise of 150mv(peak) on the inputs. Could anybody suggest as to how I can make this setup in my simulation to inject this noise?. Thanks and Regards, SBR |
Title: Re: common mode noise. Post by sheldon on Jun 7th, 2007, 3:52pm Smarty, If you have access to ADE, then why don't you try using the ideal_balun. It allows you to independently input a common- mode signal and differential-mode signal and generate differential outputs. The implementation is discussed in Ken's book, "The Designer's Guide to SPICE and Spectre". Best Regards, Sheldon |
Title: Re: common mode noise. Post by smarty on Jun 10th, 2007, 7:59pm Hi Sheldon, Thanks for your response. Best Regards, SBR |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |