The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> Analog front end design https://designers-guide.org/forum/YaBB.pl?num=1182023496 Message started by rahulfloyd on Jun 16th, 2007, 12:51pm |
Title: Analog front end design Post by rahulfloyd on Jun 16th, 2007, 12:51pm Hello everyone, Being more of a digital designer, I am currently stuck at designing an analog front end for my DSP system. This maybe a fairly basic question for most of you analog experts, so I really hope to get some helpful answers to this. The requirements for my analog signal conditioning circuit are as follows: I/P: Differential +/-2.5V O/P: Single ended 0-5V Power supplies: Either dual +/-5V or single 5V (would prefer single supply, but if solution not possible with single, then dual supply is fine). Unity gain bandwidth: Atleast 20MHz Slew rate: Atleast 10V/us. No.of channels: 4 in one IC. Moreover, this being a fixed voltage conversion, I would really like to have the biasing and/or gain setting resistors for the op-amp to be internally available. Having to connect the resistors externally is something I would like to consider only if no solutions exist with in-built components. I could not get an op-amp that matches the above requirements by going through the TI/Analog Devices op-amp selection guide, but then I could have missed out on something you guys might be aware of. I really appreciate help with this. Thank you very much. Rahul. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |