The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Mixed-Signal Design >> How to simulate the stability of sc-cmfb using hsp https://designers-guide.org/forum/YaBB.pl?num=1183301928 Message started by didibabawu on Jul 1st, 2007, 7:58am |
Title: How to simulate the stability of sc-cmfb using hsp Post by didibabawu on Jul 1st, 2007, 7:58am Because I can't use spectre,I need to simulate the stability of sc_cmfb circuit using hspice. I break the cmfb point and add the equivalent load at the output of the cmfb, then using the dc point with cmfb to doing ac analysis to see the phase margin.I'm not sure whether the method is right. Can anyone give me some suggestion? Thank you very much. |
Title: Re: How to simulate the stability of sc-cmfb using Post by boe on Jul 2nd, 2007, 3:59am Since you use AC analysis, I suppose you have a continuous-time CMFB... If you open the loop you have to make sure that you still get the same operating point... BOE |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |