The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> PSS+PAC for IIP3 simulation https://designers-guide.org/forum/YaBB.pl?num=1185285073 Message started by ZYC on Jul 24th, 2007, 6:51am |
Title: PSS+PAC for IIP3 simulation Post by ZYC on Jul 24th, 2007, 6:51am I simulate IP1dB and IIP3 for an amplifier with PSS+PAC, matched to 50ohm. The result shows that the IIP3 is not 10dB higher than IP1dB. Let's say IP1dB=-13dBm, but IIP3 is only -8dBm. I found that the IP1dB result is not the same if I took from PSS voltage gain or PAC voltage gain. One is -13dBm and the other is -18dBm. Which one is correct? Anybody met this problem before and know the reason? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |