The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Mixed-Signal Design >> how to get a sine wave output from the DAC https://designers-guide.org/forum/YaBB.pl?num=1186440146 Message started by hpham on Aug 6th, 2007, 3:42pm |
Title: how to get a sine wave output from the DAC Post by hpham on Aug 6th, 2007, 3:42pm HI, I'm using vpulse to set up binary inputs for my DAC simualtion (5 bits). As a result, when input is changing from 00000 to 11111, my current output change from 0 to 1mA in 32 steps, but then it goes back to 0 again, like a see-saw teeth. Is there a way to set up binary input going a circle so I can see a sine-wave output from the DAC?? thanks for your help ha |
Title: Re: how to get a sine wave output from the DAC Post by sheldon on Aug 7th, 2007, 4:51am Ha, Please see the following thread for an example testbench to generate a sine wave for DAC. http://www.designers-guide.org/Forum/YaBB.pl?num=1179729208/0 Best Regards, Sheldon |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |