The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> Plotting integers in Wavescan
https://designers-guide.org/forum/YaBB.pl?num=1196122189

Message started by Ken Kundert on Nov 26^th, 2007, 4:09pm

Title: Plotting integers in Wavescan
Post by Ken Kundert on Nov 26^th, 2007, 4:09pm

I went to plot an internal integer variable of a Verilog-A module and was stunned to see it plotted as a digital bus (graphical representations of the transitions with the value occasionally printed as a hexidecimal number). I could find no way of actually plotting the value. Am I missing something? Is it possible to plot integers in Wavescan and have it treat the value as an integer rather than a collection of bits?

-Ken

Title: Re: Plotting integers in Wavescan
Post by Geoffrey_Coram on Nov 28^th, 2007, 8:20am

I had no problem plotting an integer. Was there something strange about your variable name?

Title: Re: Plotting integers in Wavescan
Post by Ken Kundert on Nov 29^th, 2007, 12:56am

Geoffrey,
I've now tried it with wavescan run from the command line, and it plots integers fine, just like you showed. But when I ran from within Artist it was a different story. I don't know why they would be different. I have since lost that example, and so cannot duplicate the situation. Now I am confused.

Thanks for trying it.
-Ken

Title: Re: Plotting integers in Wavescan
Post by Geoffrey_Coram on Nov 29^th, 2007, 6:39am

Ken Kundert wrote on Nov 29^th, 2007, 12:56am:

I have since lost that example, and so cannot duplicate the situation. Now I am confused.

You originally posted on Monday, and by Wednesday night you had already lost the example? You *are* confused. :)

Title: Re: Plotting integers in Wavescan
Post by Ken Kundert on Nov 29^th, 2007, 9:27am

Indeed.