The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> how to run spectre by netlist only https://designers-guide.org/forum/YaBB.pl?num=1198212989 Message started by jlee on Dec 20th, 2007, 8:56pm |
Title: how to run spectre by netlist only Post by jlee on Dec 20th, 2007, 8:56pm Dear all, How can I run spectre/specreRF simlation by netlist only instead of the traditional way, i.e. capature a schematic, use ADE to generate a netlist and then run simulation? Thanks Jason Lee |
Title: Re: how to run spectre by netlist only Post by rajdeep on Dec 20th, 2007, 10:02pm Hi Jason, It is pretty easy. Just type spectre <netlist.scs> in your terminal. If the path is not set for spectre then you have to give the absolute path for spectre. One easy way to find the exact command that ADE runs when you press RUN+SIMULATION button is to go to the simulation directory (where all your simulation data get dumped) and look for the script runsimulation. Hope, that helps. Rajdeep |
Title: Re: how to run spectre by netlist only Post by jlee on Dec 20th, 2007, 10:18pm Got it! Thanks, Rejdeep |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |