The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> connect modules in AMS simulator https://designers-guide.org/forum/YaBB.pl?num=1199265462 Message started by rajdeep on Jan 2nd, 2008, 1:17am |
Title: connect modules in AMS simulator Post by rajdeep on Jan 2nd, 2008, 1:17am Hi all, I'm having the following error while elaborating a mixed signal design with AMS simulator. Quote:
By default this ConnRules5V_full is showing in the box, but not picking up during elabaoration. From command line I used to compile the connet rule module and the two modules (logic2elect and elect2logic) alongwith the main design. But using GUI how to do that? Thanks in advance, Rajdeep |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |