The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> plotting out all sidebands from PNOISE analysis
https://designers-guide.org/forum/YaBB.pl?num=1201526722

Message started by vivkr on Jan 28^th, 2008, 5:25am

Title: plotting out all sidebands from PNOISE analysis
Post by vivkr on Jan 28^th, 2008, 5:25am

Hi,

I saw the option "saveallsidebands" in the PNOISE analysis and wanted to use it to see the noise contribution
due to noise folded down from higher frequencies (sidebands) in my sampled switched-cap circuit

However, I don't see any option in the outputs form after having run the simulation. All I can see is the total
noise in the band of interest but no breakup of which sideband contributes how much. Would be interesting.

Is anyone familiar with this? I am using the "tumedomain" oiption to look at sampled noise at a given point
in a given band from various sidebands.

Regards
Vivek