The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> laplace LPF and Phase noise simulation https://designers-guide.org/forum/YaBB.pl?num=1202381159 Message started by tru-la-la on Feb 7th, 2008, 2:45am |
Title: laplace LPF and Phase noise simulation Post by tru-la-la on Feb 7th, 2008, 2:45am Hi! I simulate phase noise from LO through mixer with PSS+Pnoise. All blocks are implemmented with veriloga. One mixer input is connected to the DC signal, another to LO. With this setup I get the correct results of the phase noise at the mixer output. The problem comes when I connect low pass filter (which is modeled with laplace function) between DC signal and mixer. The phase noise at the mixer output drops down proportionally to the filter cut-off frequency, i.e. the higher the frequency, the lower phse noise I get. Same order of the filter implemmented as a RC chain gives the correct result. Any clues where to start digging into this problem? |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |