The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Mixed-Signal Design >> Comparator's linearity for SAR ADC https://designers-guide.org/forum/YaBB.pl?num=1203029863 Message started by Leila on Feb 14th, 2008, 2:57pm |
Title: Comparator's linearity for SAR ADC Post by Leila on Feb 14th, 2008, 2:57pm Hi, My intention is to design a comparator, I choose the NMOS Diff amplifier with PMOS load and used the resistor CMFB, for my ADC precision I need to get a gain about 32. I sweep the input common mode with the range between 300mV and 600mV, then I see 25% variation in circuit gain for this sweep in input. I force all transistor to work in subthreshold, I know the short channel effect makes to reduce the gds, I tried to remove the change in the current tail now I get the 5% change in gm compare with 18%. But still could not see constant gain. Sounds that I am not in the right way. Is there any way to make the gain for different input common mode approximately constant? Or I should not worry about the linearity and if in the worse-case I get enough gain and for the rest more gain that will be fine for my ADC? Please Advice, Thanks |
Title: Re: Comparator's linearity for SAR ADC Post by vivkr on Feb 14th, 2008, 11:00pm Hi, I would just try to make sure that the comparator has enough gain in the entire range of interest. The comparator should have enough gain to amplify a relatively small signal into fullscale logic levels (when a latch is included) And this should be done within the available time. Regards Vivek |
Title: Re: Comparator's linearity for SAR ADC Post by fonseca.ha on Feb 15th, 2008, 5:18am Hi If the input common mode can be as small as 300mV it seems that an NMOS differential pair may not be the best solution. I think that the current source that bias the differential pair may be without headroom. what is the value of your sypply? can you consider using a PMOS diff pair? Regards, Humberto |
Title: Re: Comparator's linearity for SAR ADC Post by vivkr on Feb 15th, 2008, 6:22am fonseca.ha wrote on Feb 15th, 2008, 5:18am:
Or you can use a capacitively coupled comparator. The input common mode levels are freely chosen by you to optimize performance. The input common mode variation goes out of the picture completely. So your original problem does not exist here anymore. Vivek |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |