The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> Monte Carlo Model Selection
https://designers-guide.org/forum/YaBB.pl?num=1204016942

Message started by rajath on Feb 26^th, 2008, 1:09am

Title: Monte Carlo Model Selection
Post by rajath on Feb 26^th, 2008, 1:09am

Hi all,

I plan to run a monte carlo analysis on a circuit for mismatch, and when I checked the model files, there seem to be two sections I can choose from: mc and stat. What exactly is the difference between these two models? Appreciate any help!

regards,
rajath

Title: Re: Monte Carlo Model Selection
Post by bernd on Feb 26^th, 2008, 6:31am

The stat section 'statisics block' specifies the statistical distribution,
process variation. It defines which parameter and how should be varied through
a Monte Carlo simulation.

The mc section then should include the transistor model with the parameters
to vary.

Best is to check yourself your model file.

Bernd

Title: Re: Monte Carlo Model Selection
Post by bernd on Feb 26^th, 2008, 6:38am

Parallel or at least related thread.
http://www.designers-guide.org/Forum/YaBB.pl?num=1203976519

Bernd