The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> how to use cmdmprobe in stb analysis https://designers-guide.org/forum/YaBB.pl?num=1204029625 Message started by Julian18 on Feb 26th, 2008, 4:40am |
Title: how to use cmdmprobe in stb analysis Post by Julian18 on Feb 26th, 2008, 4:40am hi, there. i want to analysis the stability of this full differential OTA(shown below), how to add the cmdmprobe into this circuit to do the stb analysis? Thanks. |
Title: Re: how to use cmdmprobe in stb analysis Post by James Bond on Feb 26th, 2008, 4:45am Hi, I think there is a component in the analoglib called iprobe, in order to use that , you need to put this component in between your common output from opamp and cmfb input, and run stb analysis. Hope it will help. james |
Title: Re: how to use cmdmprobe in stb analysis Post by Frank Wiedmann on Feb 26th, 2008, 4:53am See http://www.designers-guide.org/Forum/YaBB.pl?num=1190707743/1#1. Connect the positive output via the cmdmprobe with the negative input and vice versa. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |