The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> nominal run in Monte-Carlo (Spectre) https://designers-guide.org/forum/YaBB.pl?num=1204295803 Message started by parth_sv on Feb 29th, 2008, 6:36am |
Title: nominal run in Monte-Carlo (Spectre) Post by parth_sv on Feb 29th, 2008, 6:36am Hi All, Is there a way to prevent Spectre(ADE) from running nominal run when I am running Monte-carlo Analysis? There is an option called 'donominal' which when set to 'no' does the above - however such option is available only in command line and I dont fnd that in Monte-Carlo GUI. Thanks in Advance, Partha |
Title: Re: nominal run in Monte-Carlo (Spectre) Post by thechopper on Mar 3rd, 2008, 4:55pm Hi, As far as I knew, although the defaults settings in the Spectre ADE for the Monte-Carlo analysis are in "nominal", this analysis did not run such nominal corner but one according to the Monte-Carlo parameters that should be loaded in the Model files section. Tosei |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |