The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> PARAMETER HAS NOT BEEN SET (Spectre) https://designers-guide.org/forum/YaBB.pl?num=1204763420 Message started by firsttimedesigning on Mar 5th, 2008, 4:30pm |
Title: PARAMETER HAS NOT BEEN SET (Spectre) Post by firsttimedesigning on Mar 5th, 2008, 4:30pm everytime I simulate my circuit, it always says that PARAMETER HAS NOT BEEN SET: spectre, does anyone know how to solve this problem? thx The simulator I am using is spectreS and I get this error only when I use spectreS. If I use other simulators, for example, spectre, then I dont get this type of error. Even though, the model and parameter files that I use are the same. So I am guessing the problem is within the file...but I am not so sure.... Another error that I had faced is that when the simulator starts to generate the netlist, spectre would shut down on itself. All the spectre windows would close and it would return a segmentation fault. Anyone knows how to solve these problems? |
Title: Re: PARAMETER HAS NOT BEEN SET (Spectre) Post by Geoffrey_Coram on Mar 7th, 2008, 6:15am Spectre is the simulator. Something else (ade?) is responsible for generating the netlist. You should be clear about what is what. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |