The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> Noise Summary after PSS and Pnoise Run https://designers-guide.org/forum/YaBB.pl?num=1210019348 Message started by GusTheCat on May 5th, 2008, 1:29pm |
Title: Noise Summary after PSS and Pnoise Run Post by GusTheCat on May 5th, 2008, 1:29pm Hello, I have been looking for this for a while and did not seem to find the answer. If I run a PSS and then a Pnoise on an oscillator, to get the phase noise, then I say "Print Noise Summary" at 100 kHz (Frequency Spot). Is this the spot noise at 100 kHz from the oscillator frequency, or it is 100 kHz from DC? Thanks. |
Title: Re: Noise Summary after PSS and Pnoise Run Post by ACWWong on May 5th, 2008, 2:03pm http://www.designers-guide.org/Forum/YaBB.pl?num=1202602303/1#1 |
Title: Re: Noise Summary after PSS and Pnoise Run Post by GusTheCat on May 5th, 2008, 2:06pm Many many thanks! |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |