The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> Wrong Phase Noise Results during Parametric Sweep https://designers-guide.org/forum/YaBB.pl?num=1210451942 Message started by GusTheCat on May 10th, 2008, 1:39pm |
Title: Wrong Phase Noise Results during Parametric Sweep Post by GusTheCat on May 10th, 2008, 1:39pm Folks, When I sweep a parameter, like a voltage, for an oscillator, sometimes there will be a few bad phase noise point, where it is very high. Make a single-run, and the results back to normal. I suspect that fractional control code is a problem, but I digitize it using an ADC before sending it into the oscillator. Any hints and comments are appreciated. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |