The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> Phase noise table for a VCO in Agilent ADS https://designers-guide.org/forum/YaBB.pl?num=1210760196 Message started by sandman on May 14th, 2008, 3:16am |
Title: Phase noise table for a VCO in Agilent ADS Post by sandman on May 14th, 2008, 3:16am Hi, This is probably a question for a HP/Agilent ADS user forum, but I couldn't get help for it anywhere else. In a phase noise simulation, I'm looking to add phase noise to a VCO (V_1Tone source) by means of a phase noise table (Frequency->Corresponding Phasenoise@Frequency). This is usually done using the DataAccessComponent, but I've not been able to get it to work. If there's anybody who's familiar with this, I would be thankful for their help ! Cheers ! |
Title: Re: Phase noise table for a VCO in Agilent ADS Post by pancho_hideboo on May 14th, 2008, 7:02am I can't find any design issue in your post. Your question is not design issue but simple usage of EDA tool. Please post to "The Designer's Guide Community Forum ≫ Simulators ≫ RF Simulators". sandman wrote on May 14th, 2008, 3:16am:
I can not find your post in "Agilent EEsof Forums". Did you post to "Agilent EEsof Forums" ? If you post there, I can answer there. Agilent Home >Products & Services > Test & Measurement > Agilent EEsof EDA > EEsof Knowledge Center > Discussion Forums Agilent EEsof Forums > ADS > Analog Simulation https://edasupportweb.soco.agilent.com/cgi-bin/yabb/YaBB.pl sandman wrote on May 14th, 2008, 3:16am:
Why do you use "DataAccessComponent" ? Do you understand use model of "DataAccessComponent" ? You can set phase noise data using list() function very simply. See manual of ADS. http://eesof.tm.agilent.com/docs/adsdoc2005A/ccsrc/index.html You want to set phase noise via external file instead of directly setting ? It might be possible, if you invoke makearray() and access_data() functions. If you need more informations, post to "Agilent EEsof EDA > EEsof Knowledge Center > Discussion Forums". There you can get many answers from Agilent's guys and ADS's expert users. If no one answered, I will answer you there. |
Title: Re: Phase noise table for a VCO in Agilent ADS Post by sandman on May 19th, 2008, 9:30am Thanks for your reply, pancho_hideboo. I had tried it using the 'list' function, but I found using the dataaccesscomponent more flexible :). I can't seem to find a reference for that document (from ADS) which explained how to perform phase noise analysis, employing the dataaccesscomponent. In anycase, I've found another work around ! |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |