The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> AMS Simulators >> passing parameters in AMS-simulator
https://designers-guide.org/forum/YaBB.pl?num=1211531843

Message started by Pavel on May 23^rd, 2008, 1:37am

Title: passing parameters in AMS-simulator
Post by Pavel on May 23^rd, 2008, 1:37am

Hello,

I want to compare the behaviour of my schema in environments - ADE and AMS.
The schema includes some sources, taken from analogLib, that are parametrized.
In ADE it's OK - I pass parameters via dedicated option in ADE.
But how should I proceed in AMS - add CDF parameters for concerned sources or there is more simple way
somewhere in AMS interface.

Thanks in advance.

Regards

Title: Re: passing parameters in AMS-simulator
Post by Stefan on May 23^rd, 2008, 1:54am

I don't get it.
In Cadence you can use the ADE Frontend for spectre or AMS simulator. So the look'n'feel is the same.

Regards,

Stefan

Title: Re: passing parameters in AMS-simulator
Post by Pavel on May 23^rd, 2008, 2:12am

Hello Stefan,

Thanks for response. But how to acces/select AMS-simulator in ADE.
If it's long to explain, could you tell me in what manual can I get this information.

Regards.

Pavel.