The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Question about simulation ICMR (input common mode) https://designers-guide.org/forum/YaBB.pl?num=1211860775 Message started by chungming on May 26th, 2008, 8:59pm |
Title: Question about simulation ICMR (input common mode) Post by chungming on May 26th, 2008, 8:59pm Hi ~~ If I have a two stage single ended differential amp, and the input is rail to rail (has NMOS & PMOS as input stage), but output is cascode configuration (two nmos cascode & two pmos cascode). When simulation ICMR we often use unit gain configuration, connect Vin- to Vout so Vin- = Vout, then sweep Vin+. Vin can rail to rail, but Vout can’t … The ICMR will limit by output swing. How to simulation real input common mode range ?? Thanks !! |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |