The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> automatic table of results from corner analysis
https://designers-guide.org/forum/YaBB.pl?num=1211882984

Message started by vivkr on May 27^th, 2008, 3:09am

Title: automatic table of results from corner analysis
Post by vivkr on May 27^th, 2008, 3:09am

Hi,

I am trying to figure out how I can get the Analog Design Environment from Cadence to give me a table of selected scalar results along with the corner information.
Also good would be if a table of min./max. outputs and corresponding corners are included. This would be useful for documentation purposes.

By default, the ADE output only gives a corner number, and min./max. values are not gleaned from the data. Any suggestions would be welcome.

Regards
Vivek