The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> ncsim: *internal* (sv_seghandler - trapno -1) https://designers-guide.org/forum/YaBB.pl?num=1213908576 Message started by Upemba on Jun 19th, 2008, 1:49pm |
Title: ncsim: *internal* (sv_seghandler - trapno -1) Post by Upemba on Jun 19th, 2008, 1:49pm Is any body familiar with the following error while running an AMS simulation in ADE. Thanks |
Title: Re: ncsim: *internal* (sv_seghandler - trapno -1) Post by Stefan on Jun 19th, 2008, 1:55pm Yes - it's an internal error that occurs sometimes. You really need to give some more informations, like sourcecode and so on to be able to tell if this is a common error. Otherwise a complete bug report to cadence is your only possibility... |
Title: Re: ncsim: *internal* (sv_seghandler - trapno -1) Post by jbdavid on Jun 19th, 2008, 7:59pm happens a lot .. bad code poorly written verilog and various other reasons.. etc.. if you have this it means you hit a corner case cadence hasn't written a real message for.. two choices.. retrace your steps and figure out where you made the mistake.. or Call cadence. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |