The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> spectre simulation setup for warnings and errors ? https://designers-guide.org/forum/YaBB.pl?num=1216907912 Message started by taofeng on Jul 24th, 2008, 6:58am |
Title: spectre simulation setup for warnings and errors ? Post by taofeng on Jul 24th, 2008, 6:58am Hi, I am wondering how to make sure I can see all the warning and error messages ? thanks, Jeffrey |
Title: Re: spectre simulation setup for warnings and errors ? Post by pancho_hideboo on Jul 25th, 2008, 4:12am taofeng wrote on Jul 24th, 2008, 6:58am:
I can't find any design issue in your post. Your question is not design issue but simple usage of very specific EDA vendor's tool. Please post to "The Designer's Guide Community Forum ≫ Simulators ≫ Circuit Simulators". Usually warnings which exceed some limit numbers are suppressed in Cadence Spectre. Do you want to deactivate this suppression of warning ? |
Title: Re: spectre simulation setup for warnings and errors ? Post by taofeng on Jul 25th, 2008, 5:51am yes, you are right ! |
Title: Re: spectre simulation setup for warnings and errors ? Post by pancho_hideboo on Jul 29th, 2008, 10:05pm Add the following to netlist. aho options maxwarnstologfile=3000 See the results of "spectre -h options" maxwarnstologfile=5 Maximum number of times any warning message will be printed to the log file per analysis. Note that this option has no effect on warnings printed as part of parsing the netlist. Please use the -maxwarnstolog command line option to control the number of all warnings printed to the log file. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |