The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Measurements >> Phase Noise and Jitter Measurements >> How to increase the standard deviation of jitter https://designers-guide.org/forum/YaBB.pl?num=1218680944 Message started by pkd on Aug 13th, 2008, 7:29pm |
Title: How to increase the standard deviation of jitter Post by pkd on Aug 13th, 2008, 7:29pm Hi all, I have a PLL which takes a sinusoidal input and converts it to square wave with a frequency set by the control bits. I want to perform an experiment by increasing the standard deviation of the jitter (but keeping the Gaussian behavior of jitter in tact). How can I do that from the external control? Thanks in advance. :) -pkd |
Title: Re: How to increase the standard deviation of jitter Post by Stefan on Aug 14th, 2008, 11:02am Hi PKD, you should read some more literature about jitter in PLL's. Your question does not allow to judge, which jitter of which block you want to vary. If you're just curious in checking the effect of any jitter on the output, either vary your reference frequency or change the kVCO of your VCO with a gaussian pulse. Regards, Stefan |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |