The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> how to print component parameter value in simulation https://designers-guide.org/forum/YaBB.pl?num=1221566056 Message started by tempora on Sep 16th, 2008, 4:54am |
Title: how to print component parameter value in simulation Post by tempora on Sep 16th, 2008, 4:54am Hi, I have a resistor divider. It consists of two resistors which models have w and l parameters among others. I would like to run monte carlo dc analysis on this circuit and plot w or/and l of the mentioned resistors vs monte carlo run. How to do this? I save: Model Parameters info Elements info Output Parameters info Primitives Parameters info into raw file yet I don't find the component parameters inside the result file. Is it possible at all to show component parameters in ADE spectre simulation results? Thanks for your inputs, L.S. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |