The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> how to set initial condition in post-extracted netlist in ADE
https://designers-guide.org/forum/YaBB.pl?num=1221575657

Message started by Dipankar on Sep 16^th, 2008, 7:34am

Title: how to set initial condition in post-extracted netlist in ADE
Post by Dipankar on Sep 16^th, 2008, 7:34am

Dear All,

How can I set initial condition at some node of a post-extracted netlist from ADE?

The rc-extracted file (that I include in model library section) is ***.spf and I use hier-editor to use the spectre view of the top block.

Dipankar.