The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Mixed-Signal Design >> DC Op Pt of R-S F/F https://designers-guide.org/forum/YaBB.pl?num=1221766892 Message started by wave on Sep 18th, 2008, 12:41pm |
Title: DC Op Pt of R-S F/F Post by wave on Sep 18th, 2008, 12:41pm Hello - I'm using Cross coupled NOR gates in a couple mixed signal paths. DC op pt seems to be a problem, as they are symmetric. (no offsets) Often the solution is a midpoint of VDD burning shoot thru current. I've used spectre Nodeset on the Set/Reset inputs successfully in one case. In another instance, there is Feedback around an analog loop, and that whole loop locks up to a mid-point. Not sure if this is a real ckt problem (I inherited the design). I'd prefer not to run a transient to clear the Flop. Short of that solution, any suggestions? thanks, Wave 8-) |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |