The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> model info from opt in ADE calculator https://designers-guide.org/forum/YaBB.pl?num=1222105387 Message started by Dipankar on Sep 22nd, 2008, 10:43am |
Title: model info from opt in ADE calculator Post by Dipankar on Sep 22nd, 2008, 10:43am Hi All, I am tryng to Cg of a nmos_cap from opt in calculator but the timepoint at which I need to get this is not known before simulation. So I can't put the time value in timeinfo in transient analysis option. Any idea of workaround ? Dipankar. |
Title: Re: model info from opt in ADE calculator Post by Tlaloc on Sep 22nd, 2008, 7:12pm First off, I am assuming that you are running your simulation using Spectre. With that, you can save device parameters for the transient sim. The format is Code:
I have not figured out how to do this through ADE. What I have done in the past is to create a file with the save command, and include that file through ADE. That works just fine even if it is a bit bothersome. I should note that I haven't tried too very hard to figure out if there is another way. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |