The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Analog Design >> frequency stability
https://designers-guide.org/forum/YaBB.pl?num=1222771171

Message started by raja.cedt on Sep 30th, 2008, 3:39am

Title: frequency stability
Post by raja.cedt on Sep 30th, 2008, 3:39am

hi all,
        i have basic doubt regarding Frequency compensation.
Normally when amplifiers in the loop are very fast means they give less phase shift, so more stable.But when we do dominant pole compensation intensionally we reduce the pole  frequency means we are making system slow hence system became stable with slow amplifiers..can you explain whats wrong in that.
THANK YOU

Title: Re: frequency stability
Post by Berti on Sep 30th, 2008, 4:04am

I think you completely misunderstand frequency compensation / pole splitting.

For a system to be stable you need sufficient phase-margin.
1 pole shift the phase by 90 degree.
2 poles shift the phase by 180 degree.

Since an amplifier has more than 1 pole, you need a first dominant pole at
low frequency to make sure that the gain is low (typically <0dB) at the frequency
where the second pole comes into play (in shift the PM by another 90 degree).
This can is the purpose of compensation.

Regards

The Designer's Guide Community Forum » Powered by YaBB 2.2.2!
YaBB © 2000-2008. All Rights Reserved.