The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> Circuit Simulators >> Stuck with the DCmatch analysis in Cadence?
https://designers-guide.org/forum/YaBB.pl?num=1224420049

Message started by hotraymanf on Oct 19^th, 2008, 5:40am

Title: Stuck with the DCmatch analysis in Cadence?
Post by hotraymanf on Oct 19^th, 2008, 5:40am

:'(Our process does not have the parameter for dcmatch in the model card, especially mvtwl. So I just mannuly add one paremeter mvtwl after the orignal model card. The problem in the DC simualtion this newly added paremeter can not be recognized and printed out still to be zero. And also in the dcmatch result it only display zero. Can someome help me out?
Thank you very much!

Title: Re: Stuck with the DCmatch analysis in Cadence?
Post by ywguo on Oct 20^th, 2008, 3:49am

It looks interesting to run a dcmatch analysis for an opamp or a comparator. Do you have any manual or tutorials on the dcmatch analysis? Thank you.

Yawei

Title: Re: Stuck with the DCmatch analysis in Cadence?
Post by Andrew Beckett on Jan 2^nd, 2009, 3:24pm

If you search on sourcelink for "dcmatch appnote" you'll find an application note on this. I think this is probably part of the documentation nowadays though.

Andrew.