The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> How to simulate charge pump noise? https://designers-guide.org/forum/YaBB.pl?num=1225251794 Message started by jlee on Oct 28th, 2008, 8:43pm |
Title: How to simulate charge pump noise? Post by jlee on Oct 28th, 2008, 8:43pm Hi guys, I have following questions about charge pump noise simulation? 1. When I use this charge pump noise to model pll noise, I should use noise PSD (A/sqrt(Hz)) or phase noise (dBc/Hz)? 2. Assume I try to use noise PSD, which simulation I should run by noise, pnoise or others ... ? Thanks in advance |
Title: Re: How to simulate charge pump noise? Post by zwtang on Nov 4th, 2008, 4:30pm Hi jlee I think PSD noise should be obtained first from PNOISE analysis. The phase noise contribution from CP equals PSD noise multiplying its transfer function. zwtang |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |