The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Other CAD Tools >> Entry Tools >> In Composer, pass down parameters for veriloga block https://designers-guide.org/forum/YaBB.pl?num=1238699177 Message started by neoflash on Apr 2nd, 2009, 12:06pm |
Title: In Composer, pass down parameters for veriloga block Post by neoflash on Apr 2nd, 2009, 12:06pm Need help to pass down the parameters in cadence composer, for veriloga blocks. Thanks. |
Title: Re: In Composer, pass down parameters for veriloga block Post by Andrew Beckett on Apr 4th, 2009, 2:45pm If you just specify the parameters in your Verilog-A code, when you exit the editor (after saving), it should automatically define these parameters in the CDF. When you instantiate the block, you'll probably need to use the "Use Tool Filter" cyclic field on the edit properties form, and then you should be able to see any of the parameters you defined in the VerilogA code - and you can set them on the instance. Best Regards, Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |