The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> RF Design >> Output back-off requirement for RRC filtered digital Signal https://designers-guide.org/forum/YaBB.pl?num=1239801941 Message started by AnalogAroma on Apr 15th, 2009, 6:25am |
Title: Output back-off requirement for RRC filtered digital Signal Post by AnalogAroma on Apr 15th, 2009, 6:25am Hi Everybody, In ourZigbee 868.3 MHz transceiver project , a RRC filter with roll-off factor 0.2 is used in the transmitter side. The modulation is BPSK with multi-level ASK. What should be the output power back-off requirement for the power amplifier ? What is the PAPR for this roll-off factor ? Does anyone know the equation for this back-off relation ? |
Title: Re: Output back-off requirement for RRC filtered digital Signal Post by pancho_hideboo on Apr 15th, 2009, 6:47am See http://www.designers-guide.org/Forum/YaBB.pl?num=1190971685/7#7 |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |