The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Design >> Analog Design >> how to get and decrease the offset of a comparator ? https://designers-guide.org/forum/YaBB.pl?num=1239882120 Message started by frankdhz on Apr 16th, 2009, 4:41am |
Title: how to get and decrease the offset of a comparator ? Post by frankdhz on Apr 16th, 2009, 4:41am how to get and decrease the offset of a comparator ? |
Title: Re: how to get and decrease the offset of a comparator ? Post by raja.cedt on Apr 16th, 2009, 4:54am hi, please post the circuit schematic or rough ckt which was in your mind,because there are so many comparator architectures., Lets say you are using any preamplifier in front of your comparator then 1.decrease the overdrive of the differential pair 2.increase the sizes of the differential pair 3.try to bias the stage with less bias current. 4.Try to minimize the gm of the diode connected load pmos (if any) Thanks, Rajasekhar. |
Title: Re: how to get and decrease the offset of a comparator ? Post by kidman on Apr 17th, 2009, 2:37pm http://inst.eecs.berkeley.edu/~ee247/fa08/index.html This is the course website of ADC course from berkeley. Lecture 20 is all about comparator design and has lots of methods for offset cancellation/reduction. I recommend you watch the lecture video too |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |