The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> How to turn off model related warning in hspice simulator? https://designers-guide.org/forum/YaBB.pl?num=1240351561 Message started by neoflash on Apr 21st, 2009, 3:06pm |
Title: How to turn off model related warning in hspice simulator? Post by neoflash on Apr 21st, 2009, 3:06pm For example, some models are not used and there is going to be many warnings, which make the real important info hard to find. **warning** (/tt_lk.l:10414) model nch_lvt.1 is not used in netlist |
Title: Re: How to turn off model related warning in hspice simulator? Post by nobody on Apr 21st, 2009, 7:03pm I think you can try to turn off that model in the model card directly. |
Title: Re: How to turn off model related warning in hspice simulator? Post by Geoffrey_Coram on Apr 28th, 2009, 5:18am Check your .option statement; I wonder if you're somehow requesting those warnings, I don't think I usually get them. Also consider NOMOD or BRIEF |
Title: Re: How to turn off model related warning in hspice simulator? Post by spiceoracle on May 7th, 2009, 3:17pm By default, HSPICE only loads the models that are actually used by the circuit. This has been the default behavior since the A-2008.03 release. Doing this saves memory and run time since every model and model bin is not loaded and evaluated during the read in phase. Using .option brief=1 and brief=0 around any .lib statements will prevent HSPICE from reporting which models are not used. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |