The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> Monte Carlo Similulation in ADE XL https://designers-guide.org/forum/YaBB.pl?num=1241155007 Message started by Fadi on Apr 30th, 2009, 10:16pm |
Title: Monte Carlo Similulation in ADE XL Post by Fadi on Apr 30th, 2009, 10:16pm I was trying to figure out how to run a monte carlo simulation in ADE XL. Can some one help me with this or point to a good tutorial on the subject. Thnx |
Title: Re: Monte Carlo Similulation in ADE XL Post by Andrew Beckett on May 1st, 2009, 5:37am Did you try reading the manual? With IC612/IC613 you should be able to either invoke "cdnshelp" from the command line, or use the Help menus in the tools to navigate the help system. Worst case, take a look at <ICinstDir>/adexl/adexl.pdf In the version I looked at (latest IC613 ISR), Chapter 7 is "Performing Monte Carlo Analysis". Regards, Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |