The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Other CAD Tools >> Physical Verification, Extraction and Analysis >> How to configure neocircuit?
https://designers-guide.org/forum/YaBB.pl?num=1241842433

Message started by nuoan on May 8^th, 2009, 9:13pm

Title: How to configure neocircuit?
Post by nuoan on May 8^th, 2009, 9:13pm

Dear all,

our company just installed the neocircuit, we use TMSC pdk for our design. when we startup neocircuit and try to improve the circuit with neocircuit， but neocircuit says"can not get parameter from..."

we are not familiar with how neocircuit work, Could someone tell us how to configure neocircuit to work with TMSC pdk?

Thanks!

Regards,
nuoan

Title: Re: How to configure neocircuit?
Post by oermens on May 31^st, 2009, 8:38am

perhaps reading the documentation would be useful? If you're an IC5.141 user, refer here:

$CDS_TOP_DIR/IC/doc/neowizard/neowizard.pdf

If you're using IC6.1 and up, neocircuit functions are integrated into virtuoso. More discussion here: http://www.cadence.com/community/forums/T/12006.aspx