The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> RF Simulators >> How to add corner section of the transistor model into corner analysis! https://designers-guide.org/forum/YaBB.pl?num=1242853753 Message started by Jack on May 20th, 2009, 2:09pm |
Title: How to add corner section of the transistor model into corner analysis! Post by Jack on May 20th, 2009, 2:09pm Dear All, I want to use cadence/Virtuoso/ADE/corner analysis to simulate the circuit. But I didn't know how to add the corners (ss, tt, ff) of transistor model into the simulator. Anybody has the tutorial or explains the steps to me? Thank you very much! |
Title: Re: How to add corner section of the transistor model into corner analysis! Post by Andrew Beckett on Jul 10th, 2009, 6:50am Read <ICinstDir>/doc/aatoolsuser/aatoolsuser.pdf . There's a chapter in there on the corners tool. Regards, Andrew. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |