The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> Circuit Simulators >> How to measure current between draina nd source in eldo https://designers-guide.org/forum/YaBB.pl?num=1244584795 Message started by rajivs1001 on Jun 9th, 2009, 2:59pm |
Title: How to measure current between draina nd source in eldo Post by rajivs1001 on Jun 9th, 2009, 2:59pm Is there any way I could measure the current flowing between source and drain terminal of a transisotr without modifing the netlist ? Thanks, -Rajiv |
Title: Re: How to measure current between draina nd source in eldo Post by oermens on Jun 9th, 2009, 3:19pm |
Title: Re: How to measure current between draina nd source in eldo Post by rajivs1001 on Jun 9th, 2009, 3:29pm I was asking about ELDO simulator. Thanks, -Rajiv |
Title: Re: How to measure current between draina nd source in eldo Post by jiesteve on Jun 9th, 2009, 4:59pm Add the following line to your spice deck: .PROBE I(Mxx.D) or .PROBE I(Mxx.S) where Mxx is the instance name of the MOS you are interested in. |
Title: Re: How to measure current between draina nd source in eldo Post by rajivs1001 on Jun 11th, 2009, 9:21am I was under the impression that I(Mxx.D) measures current between Drain and bulk but I verified that my assumption was not correct. Thanks for the reply. Regards, -Rajiv |
Title: Re: How to measure current between draina nd source in eldo Post by Geoffrey_Coram on Jun 12th, 2009, 10:26am Note that I(Mxx.D) includes drain to bulk current, but usually that's smaller than the channel current. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |