The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design Languages >> Verilog-AMS >> Parallel input and Serial output (PISO) of USB tranceiver
https://designers-guide.org/forum/YaBB.pl?num=1258029179

Message started by somisetty on Nov 12^th, 2009, 4:32am

Title: Parallel input and Serial output (PISO) of USB tranceiver
Post by somisetty on Nov 12^th, 2009, 4:32am

Hi all,
Can any one help me regarding VerilogA code for PISO block which is shown in below diagram?
Thanks inadvance

Title: Re: Parallel input and Serial output (PISO) of USB tranceiver
Post by Riad KACED on Nov 12^th, 2009, 2:47pm

http://www.designers-guide.org/Books/dg-vams/index.html

Title: Re: Parallel input and Serial output (PISO) of USB tranceiver
Post by somisetty on Nov 12^th, 2009, 9:20pm

Thank you very much

Title: Re: Parallel input and Serial output (PISO) of USB tranceiver
Post by somisetty on Nov 15^th, 2009, 8:20pm

Hi KACED,

I could not able find verilogA code of Parallel input and serial output (PISO) under what you have mentioned. (http://www.designers-guide.org/Books/dg-vams/index.html).

Please give me some more information on that.
thanks

Title: Re: Parallel input and Serial output (PISO) of USB tranceiver
Post by Riad KACED on Nov 16^th, 2009, 12:38am

Hi Somisetty,

I have never said there was any.
What I meant is given the few Verilog-A/verilog-AMS you have asked in this forum, you better take a look at the Book I have mentioned.
In other words, you better taked a week or 2 of your time, studying verilog-A and Verilog-ams languages. Once it is all clear in your mind, then you may start looking at the hundreds of examples in this forum.
You wouldn't expect people to write a tailored model for your very specific need, would you ?

Well, if you can't afford buying the book, which is fair enough, then You can look at either the Cadence's Manuals (I posted the links in a previous post) or the Accela LRMs. I can send the links if needed.

Regards,
Riad.