The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Design >> Analog Design >> What is the basics of bias voltage for analog design?
https://designers-guide.org/forum/YaBB.pl?num=1260950786

Message started by DP_Design on Dec 16^th, 2009, 12:06am

Title: What is the basics of bias voltage for analog design?
Post by DP_Design on Dec 16^th, 2009, 12:06am

You Know who i am to read title, I am very freshman in Analog circuit.
So, please give me your generosity... ;D

Question:
Most of the analog circuit needs some bias voltage.

Is there some rule on bias voltage selection?
Simply should I do simulation and find the condition or size of transistor for saturation mode by trial and error?
Or should I manually calculate all transistor's DC level for saturation and start to satisfy calculation result ?

And is there any best way to select proper transistor size?
If i choose the bias condition, I can make the circuit in various size and scheme. Then What does make me select the best size of transistor?