The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl Simulators >> AMS Simulators >> MIXED SIGNAL SIMULATION https://designers-guide.org/forum/YaBB.pl?num=1261750493 Message started by VINAY RAO on Dec 25th, 2009, 6:14am |
Title: MIXED SIGNAL SIMULATION Post by VINAY RAO on Dec 25th, 2009, 6:14am hi,, I am using ic5141 and wrote a simple verilog-ams code for 1-bit DAC where input is digital signal and output is analog.After that i instantiated in schematic window for simulating it. I reffered manuels to simulate this but i am not getting any proper idea for simulating mixed design. For simulating any design, is it compulsory to go for "config" views rather than simple schematic view?? Whats the need of config view if we dnt have any hierarchial design?? |
Title: Re: MIXED SIGNAL SIMULATION Post by sheldon on Dec 25th, 2009, 4:20pm Vinay, Have you tried to simulate? Do you have a problem when you simulate? Basically, if you should be able to run ADE from Composer in this case. The only complication will come if you have a schematic view and an verilog-a view for the DAC. In that case you can control the order for netlisting using the view order list, Setup --> Environment --> Switch view list. Best Regards, Sheldon |
Title: Re: MIXED SIGNAL SIMULATION Post by VINAY RAO on Dec 25th, 2009, 9:40pm Basically DAC is verilog-ams module,where programme i wrote in verilog-ams editor and made it as a symbol and then i instantiated to simulate it. I simulated only verilog modules using verilog-xl and simulated only verilog-a modules in ADE, but i am nt gettng idea to simulate verilog-ams(here it is DAC) where input is digital bit and output is analog..After schematic if i open ADE how can i give digital bits for simulation. I am not understanding the exact flow for verilog-ams.. Thank you.. |
Title: Re: MIXED SIGNAL SIMULATION Post by sheldon on Dec 26th, 2009, 4:07am Vinay, Sorry read the append wrong. If you really have a Verilog-AMS module, then you will need to create a config view and run AMS Designer. Best Regards, Sheldon |
Title: Re: MIXED SIGNAL SIMULATION Post by VINAY RAO on Jan 1st, 2010, 9:59pm hi,,thanx.. i simulated through ams,,its wrkng fine.. thank you.. |
The Designer's Guide Community Forum » Powered by YaBB 2.2.2! YaBB © 2000-2008. All Rights Reserved. |