The Designer's Guide Community Forum

The Designer's Guide Community Forum
https://designers-guide.org/forum/YaBB.pl
Simulators >> RF Simulators >> How to simulate the IIP2 in DCR down mixer?
https://designers-guide.org/forum/YaBB.pl?num=1262087378

Message started by zzhuang on Dec 29^th, 2009, 3:49am

Title: How to simulate the IIP2 in DCR down mixer?
Post by zzhuang on Dec 29^th, 2009, 3:49am

Hi Guys,

Would you share your experiene in simulation for IIP2 for DCR down mixer? First time to run IIP2 for Mixer, hope get your kindly help!
Thanks!

Title: Re: How to simulate the IIP2 in DCR down mixer?
Post by pancho_hideboo on Dec 29^th, 2009, 4:36am

zzhuang wrote on Dec 29^th, 2009, 3:49am:

Would you share your experiene in simulation for IIP2 for DCR down mixer?

Your question is too vague.

Search all previous posts using keywords, "IP2" and "IM2" and read them.
Then repost again as clear questions.

If your question is usage of Simulator, post to Simulator's board not design's board.